beautypg.com

Velleman HAA2890 User Manual

Page 10

background image

REFRESH THE SYSTEM WITH THE “REFRESHING CODE” --- 9 9 9 9

The system can be refreshed to clear all the old data stored and back to its ex-factory default values.
IMPORTANT NOTE:
Make sure that you really want to clear ALL the OLD data before entering of the Refreshing Code. The keypad will be
back with its default values like a new unit. Re-program of the desired values are necessary.

REFRESHING CODE

The Code 9 9 9 9 is for refreshing of the system. Once it is keyed in and validated with #, all the values

programmed previously will be cleared EXCEPT the Master Code.

The refreshing takes around 2.5 minutes. During the keypad is being refreshed the Status LED (Amber) flashes fast
until the end.

THE DEFAULT VALUES OF THE KEYPAD

PROGRAMMING

LOCATION

PARAMETERS

DEFAULT FUNCTIONS & VALUES

0 1

Master Code

0 0 0 0 Factory Set, Not a default value *

0 2

Super User PINs

Nil ----- User Program Required

0 3

Common User PIN 1

Nil ----- User Program Required

1 0

User PINs & Cards for O/P 1

Nil ----- User Program Required

4 0

Visitor Codes

Nil ----- User Program Required

5 1

O/P Mode of The O/P 1

Time = 5 Sec, Momentary

6 0

Personal Safety & Lock-out

Code = 1, 10 False Code/Card Lock-out 60 Sec

7 0

User Code Entry Mode

Code = 2, Manual Entry Mode

7 1

Pacifier Tones ON-OFF Selection

Code = 1, Pacifier Tone ON

7 2

O/P Operation Announcer

Code = 1 Sec, Notification Beep ON

7 3

Status LED Standby Flashing ON-OFF

Code = 1, Flashing Enabled

9 0

Egress Delay & Warning

Code 1 = 0, Instant, No Delay
Code 2 = 1, Momentary Contact without Warning

9 4

Operation Modes

Code = 0, Stand Alone Keypad

NOTE:
The DAP Code 8 0 8 0 and the Refreshing Code 9 9 9 9 are fixed in the operating system program. It can not be
changed in any ways or be influenced by the system in default setting.

REFRESHING CODE

VALIDATION

9999

#

10

HAA2890_Manual.indd 20

24/05/2012 15:21:13