Velleman CTC1000 - Manual (Page 7)

CTC1000
V. 01 – 12/06/2013 7 ©Velleman nv
It is highly recommended to change the User 1 pin code and the master code on first use.
Cursor

The cursor is indicated by a flashing dot in the left upper corner.
 Use the keys  and  to move the cursor.
 Press OK to confirm.
The Program menu contains the following items:
Notes

A down arrow V indicates that the list can be scrolled down. The arrow disappears when you reach the
bottom of the list.
 An up arrow Λ indicates that the list can be scrolled up. The arrow disappears when you reach the top of
the list.
 Press Cancel to return to the Alarm Off display.
 In Program mode, if no key is pressed within 5 minutes, the control panel will automatically return to alarm
off mode.
7.2 Tel. Setting
In the Tel. Setting menu, you can add, change or delete the mobile phone numbers.
The control panel will use these numbers to report events.
You can add up to 6 numbers.
Notes

The display only shows the first 11 digits of a number.
 The numbers are listed in order of priority. The system will connect to the phone numbers in that order. If
the control panel fails to connect to the first number, it will try the next one on the list.
To add a phone number
1. Enter Program mode and select Tel. Settings from the menu.
The display lists the phone numbers. This list is empty on first use.
2. Use the arrow keys to select the letter to which you want to assign a number (A to F) and press OK.
3. Key in the phone number and press OK.
o The number can contain up to 20 digits and characters * & #.
o When entering a number, the key acts as backspace.