Velleman CTC1000 - Manual (Page 10)

CTC1000
V. 01 – 12/06/2013 10 ©Velleman nv
2. Use the arrow keys to select the code you want to delete and press OK.
3. Press OK again.
7.5 Temp. Code
Use
 Used to arm or disarm the alarm system for a temporary user
 Valid only once for turning the alarm on or off.
 Once used, the code is automatically erased and needs to be reset if necessary
Default value  Not set
Properties  4 digits
 Optional
 Will be cleared when resetting the system (see chapter System reset)
To set a temporary code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Temp. Code and press OK.
2. Key in a 4 digit code and press OK.
3. Repeat the code and press OK.
4. Set the option Latch Rpt. (latch key reporting) to on or off.
o This option is only visible if the Latch Option is set to ON in the Special Settings.
See section Latch Option in chapter 8 Special Settings for detailed information.
5. Press OK.
To change a temporary code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Temp. code and press OK.
2. Press .
3. Refer to topic To set a temporary code above.
To delete a temporary code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Temp. code and press OK.