Velleman CTC1000 - Manual (Page 36)

CTC1000
V. 01 – 12/06/2013 36 ©Velleman nv
31 UR#2 activate
Example: if the Listen-in communication is activated by DTMF01, no DTMF command can be set for further
operation.
15.2 Remote commanding via SMS message
Remember to change the Language setting of your mobile phone to English before proceeding.
SMS Remote Control Command Table
Control Command
Action
00 hang up with Confirmation
10 disarm
11 arm
20 UR#1 deactivated
21 UR#1 activated
30 UR#2 deactivated
31 UR#2 activated
For 2-digit Remote Control Command
Send the SMS message to command the Unit to enter Arm Mode and send a confirmation SMS back to your
mobile phone. The format is:
M I C H A E L * 1 2 3 4 1
1 0 0
The
programmed
SMS keyword User pin
Code
Remote
Control
Command
A confirmation SMS message will read on your mobile phone as: Confirmation, MICHAEL* 1234 11 00
Send the SMS message to command the Unit to enter Arm Mode without a confirmation SMS back to your
mobile phone. The format is
M I C H A E L * 1 2 3 4 1
1
The programmed
SMS keyword User
pin
Code
Remote
Control
Command
The system will automatically filter through all incoming SMS messages for SMS Keyword and automatically
ignores and deletes SMS which does not contain the SMS keyword. For all authorized remote command that
comes with proper keyword and pin code, the system will immediately carry out the contained command(s) and
delete the SMS message afterward.
16. System reset
When resetting the control panel, all programmed parameters (including pin codes) are reset to factory defaults
and all devices are removed. You have to do the programming and add the devices one by one again.
The control panel can clear all programmed parameters by the following sequence:
1. Remove the power supply and remove the backup battery.
2. Apply power while holding down the  key.
3. Release the  key when you hear a tone.
The control panel will display Enter Code.
4. Enter the following key sequence: , OK key
5. Press OK.
If you enter an incorrect key, the unit will revert to normal Alarm On mode.