Atdec Telehook TH-3060-UFH Installation manual - Manual (Page 3)

A. Prior to attaching your Display check which of the three pairs
of keyhole mounting positions on the Display Mount to use that
will also allow access to the lower mounting slots.
C. Attach M6 x 6mm screws
to the lower mounting rail, to
secure the display
If the Display drops down the spring
tension will need to be increased
If the Display rises the spring tension
will need to be decreased
B. To adjust the tension use
the supplied 6mm Allen Key
More tension for
heavier displays
less tension for
lighter displays
13°
loosen the nuts on both sides
of the tilt mount
Adjust the Display to the
desired viewing angle
Tighten nuts to secure position
keyholes
screws
Wall
Wall
A. The Arm may need to be adjusted to
suit the weight of the display
B. Hook the screws in the top mounting
bracket into your chosen
pair of keyhole
mounting
positions on the
display mount
Turn left nut
Anti-clockwise
Nuts
Turn right nut
Clockwise
Nuts
Turn right nut
Anti-clockwise
Turn left nut
Clockwise
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to the continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 07.09.12 ©
Step 9. Attach Display to Display Mount
Step 10. Display Height Adjustment
Step 11. Tilt Adjustment
Installation complete