Atdec Telehook TH-3060-UFH Installation manual - Manual (Page 2)

PUSH
Flat screen wall mount | Full Motion height adjustable
PUSH
5° 5°
x2
The Mounting rails support VESA hole
configurations from 200mm x 200mm to
400mm x 400mm
Display mounting screw
Only insert the M6 x 6mm screws in
the mounting rail attached to the top of
the display. Tighten fully then undo one
half turn
Mounting rail
Mount
Washer
M6 Nyloc Nut
(tighten firmly)
Threaded stud
A. From the
tightened position
undo each nut a
quarter of a turn two
times
B. This will
allow 10°
Horizontal
rotation
adjustment
Note: The nuts can be re-tightened to
secure the display in position or left to allow
future changes
Step 4. Attach Wall Plate Covers
Step 6. Horizontal Rotation Adjustment
Step 8. Attach Mounting Rails To Display
Step 7. Attach Screw Covers
Step 5. Attach Display Mount to Arm