Atdec Visidec VF-AT-AA Installation manual - Manual (Page 2)

M4 Display Mounting Screws M4 Display Mounting Screws
A. Insert Tabs
B. Push In
To insert Cable Covers:
Pull out
tabs
INSERT
NOTE: If the Articulated Arms are
to be used in a multi-user
environment, use the Cable Clip
(supplied with the Visidec Focus
Mount) to secure the cables to
the pole.
Installation Complete
Step 6. Cable Management - Ensure arm is fully extended
Step 5. Replace Top Cap
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without noticed. Published 06.09.12
Step 4. Fasten Display to Articulated Arm
For displays with 75 x 75mm
(3" x 3") mounting hole patterns
For displays with 100 x 100mm
(4" x 4") mounting hole patterns
INSERT
Route the Cables underneath the Arms,
inserting the Primary and Secondary Arm
Cable Covers to hold the Cables in place.
INSERT
Primary Arm
Cable Cover
TIP: Leave enough slack
in the cables at the joints
to allow full movement.
C. Then Push Up
Secondary Arm
Cable Cover
Insert cables into the
pole slot using the
Cable Balls (supplied
with the Visidec Focus
Mount) to hold them in
place.