Atdec Visidec VF-AT-D Installation manual User Manual
Installation instructions, A component checklist, Bolt through
A Component
Checklist
- Check you have received all parts against the component checklist prior to installing
Bolt Through
Installation
Instructions
Steel washer
Bolt Through Base
M8 Desk Clamp Screw
(found in the Desk
Clamp Box)
5mm Allen
Key
9mm (³/
8
”) Hole
Drill a 9mm (³/
8
”) hole in the
work surface at the desired
position and assemble as
shown below.
NOTE:
Ensure the slot in the Pole Assembly faces away
from the user.
It is recommended that the Pole Assembly be
mounted towards the rear edge of the work surface
IMPORTANT:
The “User
Operating
Card”
must be left
with Visidec
Focus
Articulated
Arm Double
once
installed
Desk Clamp
Pole Assembly
B1
B2
m
ot
t
o
B
Slot
NOTE: When using the Desk Clamp mounting option,
the displays can only be used in side by side
configuration as shown. Failure to do so may result in
serious damage to product and displays.
Tighten
Firmly
Double Arm
Assembly
Pole Assembly
User Operating
Card
(see note at top of page)
m
o
t
t
o
B
p
o
T
Desk Clamp
Box
5mm Allen
Key
Desk Clamp Bracket
M8 Desk
Clamp Screw
Bits Box
Primary Arm
Cable Cover (x2)
Secondary Arm
Cable Cover (x2)
Bolt Through
Base
Steel
Washer
M8x30mm
Screw
Pole Top
Cap
Cable Clip (x2)
Display
Mounting
Screws
M4x16mm
(x 8)
M4x12mm
(x 8)
M4x10mm
(x 8)
Cable
Balls (x2)
Work Surface
Pole
Assembly
Step 3:
Adjust the height of the Pressure Plate to suit the
Work Surface and tighten firmly in the desired location.
5mm Allen Key
Tighten
Firmly
Step 1:
Attach the Desk Clamp Bracket to the botto m
of the Pole Assembly using the M8x30mm Screw.
Tighten
firmly using the 5mm Allen Key.
Ensure the Visidec logo is facing the front as shown.
M8x30mm
Screw
m
ot
t
o
B
Step 2:
Install the M8 Desk Clamp
Screw and Pressure Plate as shown.
Desk
Clamp
Bracket
5mm
Allen Key
Bolt Thru
Base
Pole
Assembly
Pressure
Plate
M8 Desk
Clamp Screw
5mm
Allen Key
NOTE: It is recommended that the Pole
Assembly be clamped to the rear or side
edge of the work surface
Suits 12mm
(½”)
to 38mm
(1½”)
thick work
surfaces
ADJUSTMENT RANGE
Pressure Plate
Tighten
Firmly
VF-AT-D /