Atdec Spacedec SD-POS-HA-B2B Installation manual - Manual (Page 2)

A. Loop the Security Cable (Kensington or similar)
around the internal post of the POS Height
Adjustable Assembly.
B. Feed the other end of the cable through the
POS Assembly and out the Front Cable Access Port.
C. After you have attached the monitor (as directed
in Step 8) install the lock to the monitor as per the
manufacturer guidelines.
Step 5. Install Top Cap
Step 4. (Optional) Install Monitor Security Cable (Security Cable NOT Included)
Step 6. Install Monitor Cables
Top Cap
Front Cable
Access Port
OUT
These Installation Instructions secure
the POS Height Adjustable using the
provided fasteners from above the
work surface.
For advanced Security Installation from
below the work surface. Please refer to
the Advanced Security Installation
Addendum.
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 27.07.10 ©
Position your Display at the desired viewing
angle (20° in any direction),
allowed by the VESA Ball Mount.
If the display does not hold its position,
or is too resistant, adjust the Tension Plate
(see diagram right).
To make any adjustments, use the
Tension Tool supplied.
Prior to attaching your monitor,
install the monitor cables:
IN Through the Front
Cable Access Port.
OUT
Through the Cable Access
Hole in the work surface.
OUT Through the Rear Cable
Access Port in the POS pole.
Top of
Display
There are two mounting hole configurations:
‡ [ PP
‡ [ PP
Choose appropriate Mounting Screws
from the Hardware supplied to suit
your Display.
Mounting Screws (x4)
VESA Plate
Back of Display
PP
(3”) 100mm
(4”)
PP
(3”)
100mm
(4”)
Step 7. Attach the VESA plate to your Display
Step 8. Attach your Display to the POS Assembly (Repeat for both Displays)
Step 9. Adjust the VESA Ball Mount Advanced Security Installation
PUSH
Push down firmly to attach the Top Cap.
Hook the top of the VESA plate onto
the Quickshift Mount. Gently push the bottom of the Display
into the Mount until you hear a ‘CLICK’. Insert the Security Screw, and tighten
using the 2mm Allen Key supplied.
Tighten (+kg)
Loosen
(-kg)
Tension
Plate
Tension
Tool
CLICK
PUSH
HOOK
TIGHTEN
Back of Display
Security
Screw
2mm
Allen Key
IN
OR