Atdec Telehook TH-3070-CTL Installation manual - Manual (Page 2)

Step 7. Install the Ceiling Cover
Step 9. Install the Horizontal Rail
Step 6. Set the Height of the Pole
Whilst supporting the lower half of Pole
Assembly loosen the Socket Cap Screws
(x2) using the supplied 5mm Allen Key.
Slide Pole Assembly to the
desired height.
Height Adjustment
CTL: 1050-1900mm
CTS: 550-900mm
Tighten the Socket Cap Screws
(x2) to set the height using the
supplied 5mm Allen Key. If necessary, centralise the Pole Joint
by tightening the Set Screws (x2) to suit
using the 2.5mm Allen Key.
6A
6B 6C 6D
Push up to the ceiling
Step 8. Install the Clamp Head
Loosen the three set screws
using the supplied 3mm Allen
Key.
Set Screws
ATTACH
Secure the collar with the
three set screws using the
supplied 3mm Allen Key.
8A 8B 8C
1. Loosen the 4 screws using the supplied
2.5mm Allen Key.
2. Rotate the head clamp 90° and insert
the 4 screws again using the supplied
2.5mm Allen Key.
9A. To Set Orientation NOTE: The rail mount is factory set in
the horizontal axis.
INSERT
Horizontal Rail
9B. Insert
Horizontal
Rail
9C. Secure Horizontal Rail
1. Make sure the large slot of Horizontal Rail is facing front.
2. Align the holes of the Horizontal Rail and Head Clamp.
3. Lock in place with M10 Screw and Washer using the
supplied M8 Allen Key.
If the lower pole hangs
below a suspended
ceiling, push the ceiling
cover up to the ceiling.
Large Slot