Atdec Telehook TH-2250-VF Installation manual - Manual

OR OR
Plastic Anchor (x4)
Self-Tapping Screw (x4)
Hardware
Dry Wall Anchor (x4)
M6 Washer
(x4)
M4x12/25/30mm
(x4 each)
M5x12/25/30mm
(x4 each)
M6x12/25/30mm
(x4 each)
Display Mounting
Screws
Self-Tapping Screw
M6 Washer
Wall Plate
Plastic Anchor 8mm ( 5
16
") Hole
Dry Wall Timber Stud
10mm ( 3
8
") Hole Dry Wall Anchor
Dry Wall Anchor Screw
M6
Washer
Wall Plate
Self-Tapping Screw
M6 Washer
Wall Plate
4mm ( 3
16
") Hole Timber Stud
13mm Spacer
Bush (x4)
20mm Spacer
Bush (x4)
M5x10mm
Security Screw (x4)
TH-2250-VF
Components Checklist
Wall Plate Display Plate
IMPORTANT INFORMATION
! IMPORTANT - Install Telehok 2250 Wall Mount as per Installation Instructions.
! This product supports a maximum load of 50kg (110lbs).
! This products only supports VESA compliant displays with 50mmx50mm (2"x2"), 75mmx75mm (3"x3"),
100mmx100mm (4"x4"), 120mmx180mm (4¾"x7"), 200mmx100mm (8"x4") and 200mmx200mm
(8"x8") mounting hole patterns.
! The manufacturer does not accept responsibility for incorrect installation.
Step 1. Check Components
Check you have received all parts against the component checklist and Hardware above.
Step 2. Mounting the Wall Plate
Tip: Use a spirit level to ensure wall plate is horizontal
Masonry Wall
Tools Required:
Power Drill ‡
4mm (
3
16
") drill bit ‡
Phillips Head screwdriver ‡
8mm (
5
16
") masonry drill bit ‡
10mm ( 3
8
") drill bit ‡
Spirit Level ‡
Flat Screen Wall Mount | Fixed
Installation Instructions