Atdec Telehook TH-2250-VTP Installation manual - Manual (Page 2)

Step 6. Fasten the Mounting Plate to your Display
Mounting Screw (x4)
Choose appropriate Mounting Screws
and Washers from the Hardware
supplied to suit your Display.
Washer (x4)
Top of
Display
Mounting Plate
Step 7. Attach the Display to the Wall
Step 8. Tilt Adjustment
Locking
Screw (x2)
Hook the Mounting Plate
onto the Wall Bracket.
Wall Bracket
Mounting Plate
Re-insert the two
Locking Screws
on boths sides.
Display
b b
( required)
Tighten the Lever to lock the
Display in the desired position.
Step 5. Reinstall Wall Bracket Cover
Push the two pieces of
the Cover together.
PUSH
PUSH
TILT
TILT
Installation Complete
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 06.01.10 ©
LOOSEN
Loosen the Lever before adjusting tilt.
TIGHTEN
Lever
LOWER