Atdec Telehook TH-2250-VTP Installation manual - Manual

Component Checklist
Step 1. Component Checklist
Check you have received all parts against the Component Checklist above.
Hardware
Mounting Fasteners
Step 2. Remove the Wall Bracket Cover
TH-2250-VTP
70
Installation Instructions
Nylon
Anchor (x2)
M4 Washer (x4)
M5 Washer (x4)
Wall Mount
Screw (x2)
Flat Screen Wall Mount | Tilt
M6x8mm / M6x12mm (x4 each)
M4x8mm / M4x12mm (x4 each)
M5x8mm / M5x12mm (x4 each)
M6 Washer (x4)
TOOLS REQUIRED:
UÊ*œÜiÀÊÀˆ
UÊ* ˆˆps Head Screw river
UК{““К­
3 /
16
»®КАˆК ˆМ
UКn““К­ 5 /
16
»®К>Гœ˜АЮКАˆК ˆМ
Remove the two Locking Screws,
on both left and right sides.
Step 3. Remove the Mounting Plate
Step 4. Fix the Wall Bracket to the Wall
Using the Wall Plate as a drilling template, choose from one of the following Mounting options, Timber Stud OR Masonry Wall.
Drill two holes 50mm
deep with a 4mm
drill bit.
Masonry Wall
Nylon Anchor
(x2)
Wall Mount Screw (x2)
Wall Plate
M6 Washer (x2)
Wall Plate
Wall Mount Screw (x2)
M6 Washer (x2)
Timber Stud
Drill two holes 50mm
deep with a 8mm
Masonry drill bit.
LIFT
TH-2250-VTP
(fully assembled)
IMPORTANT INFORMATION
! IMPORTANT - Install Telehook Wall Mount as per Installation Instructions.
tÊÊÊ/ii œœŽÊ7>КœХ˜МКГХ««œАМГКˆГ«>ÞÃÊÜiˆ} ˆ˜}КХ«КМœКОдŽ}К­ИИLГ®]КЬˆМ К6
-К œiКVœ˜vˆ}ÕÀ>Мˆœ˜Г\
50x50mm (2”x2”), 75x75mm (3”x3”),100x100mm (4”x4”), 200x100mm (8”x4”), 200x200mm (8”x8”).
! The Manufacturer accepts no responsibility for incorrect installation.
Cover
Locking
Screw (x2)
PULL
PULL