VEGA VEGASON 66 Foundation Fieldbus - Manual (Page 52)

l
sensor_value
-
Raw sensor value, i.e. the uncalibrated measurement value from the sensor. Unit
derives from 'Sensor_range.unit'
l
sensor_range
-
Sensor_range.unit' refers to 'Sensor_value', 'Max/Min_peak_sensor_value', 'Cal_poin-
t_hi/lo'
l
simulate_primary_value
l
simulate_secondary_value_1
l
simulate_secondary_value_2
l
Device Status
l
Linearization Type
-
Possible types of linearization are: linear, user defined, cylindrical lying container,
spherical container
l
CURVE_POINTS_1_10
-
X and Y values for the user defined linearization curve
l
CURVE_POINTS_11_20
-
X and Y values for the user defined linearization curve
l
CURVE_POINTS_21_30
-
X and Y values for the user defined linearization curve
l
CURVE_POINTS_31_33
-
X and Y values for the user defined linearization curve
l
CURVE_STATUS
-
Result of table plausibility check
l
SUB_DEVICE_NUMBER
l
SENSOR_ELEMENT_TYPE
l
display_source_selector
-
Selects the type of value, which is displayed on the PLICSCOM module
l
max_peak_sensor_value
-
Holds the maximum sensor value. Write access resets to current value. Unit derives
from 'Sensor_range.unit'
l
min_peak_sensor_value
-
Holds the minimum sensor value. Write access resets to current value. Unit derives
from 'Sensor_range.unit'
l
CAL_POINT_HI
-
Min./max.-adjustment: Upper calibrated point of the sensor. It refers to 'Cal_level_hi'.
The unit is defined in 'Sensor_range.unit' hi
l
CAL_POINT_LO
-
Min./max.-adjustment: Lower calibrated point of the sensor. It refers to 'Cal_level_lo'.
The unit is defined in 'Sensor_range.unit'
l
CAL_LEVEL_HI
Supplement
52 VEGASON 66 - Foundation Fieldbus
28795
-EN
-060731