VEGA VEGACOM 557 PC-MODEM - Interface - Manual (Page 16)

16 VEGACOM 557 - without protocol
8 VVO or VV in conjunction with VEGACOM 557
The configuration, parameter adjustment and adjustment of VEGA processing systems can
be made with VEGA Visual Operating (VVO).
For the visualisation of measured values the Visual VEGA (VV) software is available.
For the use of VVO or VV a PC is connected with the RS232C-interface of VEGACOM 557.
When this connection is not directly made via a cable, but by means of a modem via a tele-
phone net, this is called remote parameter adjustment.
After having provided the connection via the telephone net, there is no difference between the
adjustment e.g. via VVO, and the adjustment when directly connected via cable.
In the further chapters, you find the connection examples either for direct connection of the PC
or for the connection via modem.
9 Set-up
9.1 Set-up-checklist
1. Hardware requirements
• VEGACOM 557 version PC / Modem - Interface
• PC directly via interlink cable or via telephone net with modem
2. Software requirements
• VEGA Visual Operating (VVO) or Visual VEGA (VV)
3. Carry out adjustments for RS232-interface of VEGACOM 557
• Adjust Baudrate: DIL-switch basic board
• Adjust parity: DIL-switch basic board
• For modem operation the automatic modem initialisation and no parity have to be activated.
Set-up