VEGA VEGACOM 557 PC-MODEM - Interface - Manual (Page 13)

VEGACOM 557 - without protocol 13
Mounting and installation
5.2 Mounting in carrier and housing
BGT 596 or BGT LOG 571
For mounting you just have to place a module
in the requested position. A module consists
of:
- a multipoint connector acc. to DIN 41 612,
series F, 33-pole (d, b, z)
- two screws
- three coded pins
- two guide rails.
The multipoint connector is available as fol-
lows:
- Wire-Wrap, standard connection
1,0 mm x 1,0 mm
- plug connection
2,8 mm x 0,8 mm
- Termi-Point standard connection
1,6 mm x 0,8 mm
- soldering connection
- screw terminals 0,5 mm
2 .
For mounting the module, please note the
operating instructions of the carrier.
Housing type 505
This housing is equipped with a multipoint
connector. Before mounting, please check
whether or not the housing is provided with a
power supply unit.
The connection is made via screw terminals
with max. 1,5 mm
2 .