VEGA VEGABAR 61 4 … 20 mA_HART - Manual (Page 31)

6 Set up with the indicating and adjustment
module PLICSCOM
6.1 Short description
T he indicating and adjustment module is used for measured value
display, adjustment and diagnosis. It can be mounted in the following
housing versions and instruments:
l A ll sensors of the plics ® instrument family, in the single as well as
in the double chamber housing (optionally in the electronics or
connection compartment)
l E xternal indicating and adjustment unit VEGADIS 61
F rom a hardware version …- 01 or higher of the indicating and
adjustment module resp. …- 02 or higher of the corresponding sensor
electronics, an integrated backlight can be switched on via the
adjustment menu. The hardware version is stated on the type label of
the indicating and adjustment module or the sensor electronics.
Note:
Y
ou can find detailed information on adjustment in the operating
instructions manual "Indicating and adjustment module".
6.2 Insert indicating and adjustment module
T he indicating and adjustment module can be inserted into the sensor
and removed again at any time. It is not necessary to interrupt the
power supply.
P roceed as follows:
1 U nscrew the housing cover
2 P
lace the indicating and adjustment module in the desired position
on the electronics (you can choose any one of four different
positions - each displaced by 90°)
3 P ress the indicating and adjustment module onto the electronics
and turn it to the right until it snaps in.
4 S crew housing cover with inspection window tightly back on
R emoval is carried out in reverse order.
T he indicating and adjustment module is powered by the sensor, an
additional connection is not necessary.
Function/Configuration
Mount/Dismount indicat-
ing and adjustment
module
VEGABAR 61 • 4 … 20 mA/HART 31
6 S et up with the indicating and adjustment module PLICSCOM
27519
-
EN
-081209