VEGA VEGAMET 513 - Manual (Page 28)

28 VEGAMET 513
7.3 Configuration of outputs
Settings in the "extended menu"
Config
inputs Config
meas.
loop Config
outputs
Config
current
output
Current1
to
TAG -
No. 1
Volt1
to
TAG -
No. 1
Config
Volt
output Config
relay
output Config
PC/
PLC-
output Config
VEGA-
DIS
DIS 1
to
TAG -
No. 1
DIS 2
to
----
DIS 3
to
----
PC/PLC
meas.
values
PLC 1
to
TAG -
No. 1
PLC 2
to
----
PLC 3
to
----
Confi-
gura-
tion
TAG -
No. 1
%
xx,x
Param.
TAG-
No. 1
Fail
safe
relay
Relay
Stan-
dard
---- ----
----
----
PC/PLC output and DIS output:
The PC/PLC signal as well as the DIS signal
are transmitted via the DISBUS. The PC/PLC
output delivers output signals of VEGAMET
to an interface converter VEGACOM 557.
This interface converter transfers the signals
from VEGAMET via different standard
protocols to connected systems (DCS/PLC).
In the menu items "PLC 1 to" up to "PLC C
to…" the measurement loop can be allocated
or switched off.
In the menu items "PC/PLC relay status" and
"PC/PLC input status" it can be determined
that the relay mode and input status are
transmitted via the DISBUS.
Up to three external indicating elements
(VEGADIS 174) can be connected to
DISBUS. In the menu items "DIS 1 to…" up to
"DIS 3 to–" the measurement loop can be
allocated or switched off.
The current, volt and relay outputs are
allocated as factory setting to measurement
loop "TAG-No. 1". All outputs can be switched
off individually (----), i.e. they will no longer
access a measurement loop.