VEGA VEGAMET 513 - Manual (Page 13)

VEGAMET 513 13
Adjustment
4 Adjustment
4.1 Indicating and adjustment ele-
ments
Circuit board
A rotary switch is located on the circuit
board. It is used for adjustment of the instru-
ment address on DISBUS. This setting is
necessary if several VEGAMET signal condi-
tioning instruments are linked via the
DISBUS.
The adjustment range 1 … F corresponds to
the DISBUS addresses 1 … 15.
Factory setting: 1
Note:
With address 0 the VEGAMET does not par-
ticipate in the DISBUS communication.
Rotary switch
The set DISBUS address can be displayed
via the LC display without removing the in-
strument.
Note
If several VEGAMET are linked via the
DISBUS, each address must only be
assigned once!
1 LCD (4 lines with 6 figures each, illuminated) for clear text
indication
2 LED chain (yellow) for quasi-analogue indication of the
measured value
3 Keys for menu adjustment
4 Connection socket for VEGACONNECT
5 LED (red), lights if fail safe relay is deenergised
6 LED (green), lights if operating voltage is on
8 7
6
5
4
0
F
E
D
C
B
A
9
3 3
2
1
10
11
12
13
14
15
Rotary switch
Front plate
Position of the rotary switch
CONNECT
%
100
+ -
OK ESC
on
513
1
2
3 3
4
5
6