VEGA VEGAMET 513 - Manual (Page 14)

14 VEGAMET 513
Adjustment
4.2 Adjustment system
Indicating and adjustment module
%
100
+ -
OK ESC
Depending on the menu item, change value or
choose out of a list
Choose menu item
Depending on the menu item, save the set value
or change to the underlying menu
Branching point, i.e. jump to the
next lower menu with [OK]
Depending on the menu item,
interrupt adjustment or change to
the next higher menu
Indication of
- measured value
- menu item
- parameter
Reduced menu - extended menu
Two menu modes are available: the mode
"reduced menu" and the mode "extended
menu".
Note:
VEGAMET 513 is preset to automatically
place you in the menu mode "reduced menu"!
In the majority of all applications, you can
carry out the necessary settings in this menu
mode (see also chapter 4.5 Comparison of
the menu modes).
Adjustment structure
The adjustment is made via 6 keys in con-
junction with the text display. The jump from
the measured value display to the underlying
menu is made with [OK]. Use [–>] or [<–] to
change within this menu level from one menu
item to the other. A branching point is
indicated by the symbol ▼ and enables with
[OK] a jump to the underlying menu item.
Parameters can be recognised by the
absence of the symbol ▼. The value of the
parameters can be modified with [+] or [–] or
chosen out of a list. The modified value can
be saved with [OK]. To interrupt a setting
(without saving the modification), you have to
push [ESC]. A jump back to the next higher
menu item is made with [ESC]. 15 minutes
after pushing a key for the last time, an auto-
matic reset to the measured value display is
triggered. A jump back to the next higher
menu level (with ESC) is possible from each
menu item, even if no connecting line is
shown in the menu schematics.
If you are in the utmost right menu item of a
menu row and push the [–>] key, you will
immediately reach the utmost left menu item
of this row. You also reach immediately the
right menu item from the left one, if you push
the [<–] key.
These shortcuts (shown with a broken line)
are not shown in the menu schematics in
order to give a better overview.
Add’l
func-
tion
Pass-
word
on
ESC ESC ESC ESC
TAG 1
to de
fault Lang
uage
Eng-
lish
Menu
mode
Redu-
ced
Volt
out-
put 1
Prop.
to
Per-
cent
Unit
0,0%
Volt
out-
put
0/10V
Fail-
ure
mode
0V
Volt
limita
tion
on