VTech CS6114-2 (without LED) Manual (without LED) - Manual (Page 8)

5
Getting started
Battery charging
Once you have nstalled the battery, the screen ndcates the battery status (see the
table below). If necessary, place the handset n the telephone base or charger to
charge the battery. For best performance, keep the handset n the telephone base
or charger when not n use. The battery s fully charged after 16 hours of contnuous
chargng. See the table on page 29 for battery operatng tmes.
If the screen s blank, you need to charge the handset wthout nterrupton for at
least 30 mnutes to gve the handset enough charge to use the telephone for a
short tme. When the battery s low, the handset dsplays Low battery along wth a
flashing con. If you are on a call n low battery mode, the handset beeps every
50 seconds.
The followng table summarzes the battery charge ndcators and actons to take.
Battery indicators Battery status Action
The screen s blank, or
dsplays Put in charger and
flashes.
The battery has very lttle
or no charge. The handset
cannot be used.
Charge wthout nterrupton
(at least 30 mnutes).
The screen dsplays
Low battery and flashes.
The battery has enough
charge to be used for a
short tme.
Charge wthout nterrupton
(about 30 mnutes).
The screen dsplays
HANDSET X.
The battery s charged. To keep the battery charged,
place t n the telephone base
or charger when not n use.
If you place the handset n the telephone base or charger wthout pluggng n the
battery, the screen dsplays No battery.
•
Telephone base layout
/FIND HANDSET
Press once to page all system handsets (page 15). •
After you nstall the handset battery, the handset wll prompt you
to set the date and tme. The handset wll also prompt you to set
the date and tme after a power falure. For nstructons, see
Set date and time on page 12. To skp settng, press CANCEL.
Date: MM/DD/YY
Time: HH:MM --