VTech C3200 Manual - Manual (Page 52)

49
Appendix
Appendix
Energy-saving charging mode
When this mode is activated, all telephone functions, except handset battery charging, will be disabled.
To activate the energy-saving charging mode in A1410/A1420:
Unplug the telephone base power adapter from the power outlet. Unplug the telephone line cord from the telephone wall jack.
Make sure all handsets are plugged with charged batteries before proceeding.
While you press and hold
/FIND HANDSET, plug the telephone base power back to the power outlet.
After about 20 seconds, when the IN USE light starts flashing, release /FIND HANDSET and then press it again within
2 seconds. When the telephone base successfully enters the energy-saving charging mode, all keys on the telephone base
should not respond.
Press
*331734# and then press HOLD to deregister each handset manually.
When the phone successfully enters the energy-saving mode, the IN USE light turns off and you hear 3 rising beeps.
When the phone fails to enter this mode, repeat Step 1 through Step 4 above.
Note: The telephone base will be powered up as normal if you fail to press /FIND HANDSET within 2 seconds in Step 3.
To deactivate the energy-saving charging mode:
Unplug the telephone base adapter from the power outlet. Then plug the telephone base power adapter and the telephone line
cord back in. Then the telephone base is powered up as normal.
Register the handsets back to the telephone base. See page 21 for handset registration instructions.
To activate the energy-saving charging mode in a cordless handset (C3100/C3200):
When a registered cordless handset is idle, press *331734# and then press HOLD. You hear 3 rising beeps. Then put this
handset into the charger ( C3000).
To deactivate the energy-saving charging mode:
Register the handset back to the corresponding telephone base. See page 24 for handset registration instructions.
Maintenance
Taking care of your telephone
Your telephone contains sophisticated electronic parts, so it must be treated with care.
Avoid rough treatment
Place the handset down gently. Save the original packing materials to protect your telephone if you ever need to ship it.
Avoid water
Your telephone can be damaged if it gets wet. Do not use the handset outdoors in the rain, or handle it with wet hands. Do not install
the telephone base near a sink, bathtub or shower.
Electrical storms
Electrical storms can sometimes cause power surges harmful to electronic equipment. For your own safety, take caution when using
electrical appliances during storms.
Cleaning your telephone
Your telephone has a durable plastic casing that should retain its luster for many years. Clean it only with a soft cloth slightly
dampened with water or mild soap. Do not use excess water or cleaning solvents of any kind.
1.
2.
3.
4.
1.
2.
•
•
Remember that electrical appliances can cause serious injury if used when you are wet or standing in water. If the telephone base
should fall into water, DO NOT RETRIEVE IT UNTIL YOU UNPLUG THE POWER CORD AND/OR TELEPHONE LINE CORD
FROM THE WALL. Then remove the telephone by the unplugged cords.