VTech C3200 Manual - Manual (Page 22)

19
Installation
Telephone installation
The telephone comes ready for wall mounting.
Install the telephone base as shown below.
After installing the telephone base, mount it on the wall by positioning the eyelets on the telephone base against the mounting
studs of the wall plate. Then slide the telephone base down on both mounting studs until it locks into place.
Installation option - converting from wall mount to desktop position
Remove the telephone base from the wall and then place it on a flat surface.
Put the corded handset aside. On the telephone base, place a coin in the slit of the wall mount clip and rotate a half turn
(180 degrees). Then replace the handset on the telephone base cradle.
1.
2.
1.
2.
Installation
Analog corded trimstyle - A1311
Telephone wall jack
If you have High Speed Internet
Access service, a DSL filter (not
included) is required.
Telephone line jack
Telephone line cord
Eyelets