Installation, Handset battery installation, Replace a handset battery – VTech C3200 Manual User Manual

Page 27: Handset registration, Handset deregistration, Register a handset to another telephone base, Handset battery charging, By 102 1, By 1021, Fcc id screw cover

Analog cordless 1-line/2-line accessory handset - C3100/C3200

Installation

Handset battery installation

Install the battery as shown below.

Gently lift the handset cover. Do not detach the speaker wires between the handset cover and the handset.
Plug the battery connector securely into the socket inside the handset battery compartment.
Place the battery with the label

THIS SIDE UP facing up and the wires inside the battery compartment.

To replace the handset cover, align all the tabs on the handset cover against the corresponding grooves on the handset, then

firmly push downward until all the tabs lock in the grooves. Then install the screw.

Replace a handset battery

Use a narrow object to pry open the screw cover and remove the screw. Then insert a 5 mm standard screwdriver in the

provided slot and twist to open the handset cover. Do not detach the speaker wires between the handset cover and the handset.

Unplug the battery connector from the socket and then remove the battery from the handset battery compartment.
Follow Step 2 to Step 4 in

Handset battery installation above to install a new battery.

CAUTIONS:

There may be a risk of explosion if a wrong type of handset battery is used. Use only the supplied rechargeable battery (BT264392/BT266342) or

replacement battery (BT266342). To order a replacement, call 1-888-907-2007.
FCC ID is shown on the back of the cordless handset body after the handset cover is removed.
Dispose of used batteries according to the information in

The RBRC

seal on page 46.

Handset registration

Place the cordless handset on the telephone base cradle. Handset registration happens automatically the first time a cordless

handset is placed on the telephone base. When the registration process completes, the

MESSAGE WAITING LED flashes once and

you hear 3 rising beeps as confirmation. Each telephone base accommodates up to 4 cordless handsets. When you already have

4 registered handsets, you can replace one of them by a new handset if any one of the 4 registered handsets is disconnected from

the base. For example, it is out of range, or its battery is removed or depleted. The previous registered handset is then deregistered

from the telephone base.

Handset deregistration

When a registered cordless handset is idle, press

*331734# and then press HOLD. You hear 3 rising beeps as confirmation when

the deregistration process completes.

Register a handset to another telephone base

Any analog cordless 1-line handset can register to any analog cordless 1-line telephone base. Any analog cordless 2-line handset

can register to any analog cordless 2-line telephone base.
When a registered cordless handset is idle, place it on another telephone base. This cordless handset automatically registers to the

new telephone base.

Handset battery charging

The battery must be fully charged before using the cordless handset for the first time. The

CHARGE LED turns on when the

cordless handset is charging on the telephone base or charging base. The battery is fully charged after 16 hours of continuous

charging. For best performance, keep the cordless handset in the telephone base or charging base when not in use.

1.
2.
3.
4.

2.
3.

•

•
•

-6

H-

-B

102

-6

H-

-B

1021

-6

H-

-B

FCC ID

Screw

cover