beautypg.com

Telephone settings – VTech C3200 Manual User Manual

Page 28

background image

25

Telephone settings

Analog corded lobby/1-line/2-line - A1100/A1210/CL-A1110/A1220

Telephone settings

Default settings are indicated by asterisks (*).

Setting

Options

Adjustable by:

Handset earpiece volume

(for models

A1210, CL-A1110 and

A1220 only)

1, 2*, 3, 4

User and administrator

Speakerphone volume

(for models

A1210 and A1220 only)

1, 2, 3, 4, 5*, 6, 7, 8

User and administrator

Ringer volume

(for models

A1210, CL-A1110 and

A1220 only)

Low, Medium*, High

User and administrator

Ringer tone

Tone 1*, Tone 2, Tone 3

Administrator only

Flash

(for models

A1210 and A1220 only)

1 (100ms), 2 (300ms), 3* (600ms)

Administrator only

Voicemail voltage detection

(for models

A1210, CL-A1110 and

A1220 only)

Disable voicemail voltage detection,
Periodic low voltage pulse detection method,
Steady high voltage and periodic high voltage pulse

detection method

Administrator only

Ringer tone

There are 3 ringer tone options. For 2-line model (

A1220), changing the ringer tone of either LINE 1 or LINE 2 applies to both

phone lines.
To change the ringer tone:

Turn the telephone base over with the bottom side facing up. Remove the mounting bracket if it is in the desktop position.

Press the tabs of the mounting bracket as the direction indicated below to release and remove the mounting bracket from the

telephone base.

Slide the ringer tone switch to select the desired detented position, using a narrow object such as a standard screwdriver.

Install the mounting bracket again to resume its desktop position.

Flash

For 1-line and 2-line models (

A1210 and A1220), there are 3 flash duration options that can be programmed.

To change the flash duration:

Remove the faceplate and overlay if they are on the telephone base. Press

/SPEAKER on the telephone base or lift the

handset. Then press the recessed

PROGRAM key. The MUTE key flashes when in administrator mode.

Press

FLASH and you hear 3 beeps. Then press a dialing key, 1 (100ms), 2 (300ms) or 3 (600ms), to select the desired flash

duration. Press the recessed

PROGRAM key again. You hear 3 rising beeps as confirmation.

1.

2.

3.

1.

2.

Ringer tone

switch

Mounting

bracket