VTech C3200 Manual - Manual (Page 40)

37
Telephone operation
Telephone operation
Using the cordless handset and the telephone base
The cordless handset and the telephone base cannot be used on the same call. However, calls can be switched between the
cordless handset and the telephone base speakerphone.
When the cordless handset or the telephone base is in use, the
TALK key on the cordless hand set and the IN USE LED on the
telephone base illuminate.
Receive a call
The telephone rings when there is an incoming call. The IN USE LED and MESSAGE WAITING LED flash.
To answer a call using the cordless handset while it is not on the telephone base or charging base:
On the cordless handset, press
TALK or /SPEAKER. The TALK key illuminates when in use. The /SPEAKER key illuminates
when in speakerphone mode.
To answer a call using the cordless handset while it is cradled on the telephone base or charging base:
Lift the cordless handset from the telephone base or charging base. The
TALK key illuminates when in use. The /SPEAKER key
illuminates when in speakerphone mode.
To answer a call using the telephone base:
On the telephone base, press
/SPEAKER. The IN USE key and the /SPEAKER key illuminate when in use.
Place a call
To place a call using the cordless handset:
On the cordless handset, press
TALK or /SPEAKER. Listen for a dial tone and then dial the desired number, or press a
Speed Dial key on the teleph one base to dial a programmed number. The TALK key illuminates when in use. The /SPEAKER
key illuminates when in speakerphone mode.
To place a call using the telephone base:
On the telephone base, press
/SPEAKER. Listen for a dial tone and then dial the desired number, or press a Speed Dial key to
dial a programmed number. The IN USE key and /SPEAKER key illuminate when in use.
End a call
To end a call when using the cordless handset:
Press
OFF on the cordless handset or place it in the telephone base or charging base. The call ends when all handsets hang up.
To end a call when using the telephone b ase:
Press /SPEAKER.
Switch a call between the cordless handset and the telephone base speakerphone
To switch a call from the cordless handset to the telephone base speakerphone, press /SPEAKER on the telephone base.
To switch a call from the telephone base speakerphone to the cordless handset which is not on the telephone base cradle,
press TALK or /SPEAKER on the cordless handset.
To switch a call from the telephone base speakerphone to the cordless handset which is cradled on the telephone base, the
cordless handset from the telephone base.
Share a call
A maximum of four cordless handsets can be used at the same time on an external call.
To join a call:
During a call, press
TALK or /SPEAKER on ano ther cordless handset to join.
Handset speakerphone
During a call, press /SPEAKER on the cordless handset to switch between speakerphone mode and handset earpiece mode.
Redial
The last dialed number on the cordless handset or the telephone base is stored for 15 minutes.
To redial the last dialed number from the cordless handset:
Press
TALK or /SPEAKER. Listen for a dial tone. Then press REDIAL.
To redial the last dialed number from the telephone base:
Press
/SPEAKER. Listen for a dial tone. Then press REDIAL.
•
•
•
Analog cordless 1-line - A1410