VTech C3200 Manual - Manual (Page 20)

17
Installation
Analog corded 1-line - CL-A1110
Installation
Installation option - converting from desktop to wall mount position
To mount the telephone base on the wall:
Put the corded handset aside. On the telephone base, place a coin in the slit of the wall mount clip and rotate a half turn
(180 degrees). It locks into place with the protruding edge pointing towards the upper edge of the telephone base. This
protruding edge holds the handset when the phone is mounted on the wall.
Turn the telephone base over with the bottom side facing up. Press the tabs of the mounting bracket as the direction indicated
below to release and remove the mounting bracket from the telephone base.
Rotate the mounting bracket. Insert the tabs of the mounting bracket into the middle grooves on the telephone base as shown
below. Then press the tabs and push the mounting bracket into the lower grooves on the telephone base until they lock securely.
Mount the telephone base on the wall by positioning the eyelets on the telephone base and the mounting bracket against the
mounting studs. Then slide the telephone base down on both mounting studs until it locks into place.
Replace the handset on the telephone base cradle.
1.
2.
3.
4.
5.
Protruding edge
Mounting
bracket
Eyelets