VTech C3200 Manual - Manual (Page 26)

23
Installation
Charging base installation
The charging base can be adapted to desktop use or mount on a standard telephone wall plate.
Installation option - desktop position
Turn the charging base over with the bottom side facing up. Connect the power cord to the charging base.
Position the mounting bracket as shown. Insert the tabs into the upper grooves and tighten the screw to affix the
mounting bracket.
Plug the power adapter into an electrical outlet not controlled by a wall switch.
Installation option - converting from desktop to wall mount position
Unplug the power adapter from the electrical outlet.
On the telephone base, place a coin in the slit of the wall mount clip and rotate a half turn (180 degrees). It locks into place with
the protruding edge pointing towards the upper edge of the charging base. This protruding edge holds the cordless handset
when the phone is mounted on the wall.
Loosen the screw from the mounting bracket and remove the mounting bracket from the upper grooves.
Rotate the mounting bracket. Insert the tabs of the mounting bracket into the lower grooves of the charging base. Then tighten
the screw to affix the mounting bracket.
Mount the charging base on the wall by positioning the eyelets on the charging base and the mounting bracket against the
mounting studs of the wall plate. Then slide the charging base down on both mounting studs until it locks into place.
Plug the power adapter into an electrical outlet not controlled by a wall switch.
1.
2.
3.
1.
2.
3.
4.
5.
6.
Analog cordless charging base - C3000
Installation
Power cord
Protruding edge
Eyelets