VTech C3200 Manual - Manual (Page 37)

34
Analog corded 2-line - A1220
Telephone operation
Using the corded handset and the telephone base
The corded handset and the telephone base speakerphone cannot be used at the same time. However, calls can be switched
between the corded handset and the telephone base speakerphone.
Receive a call
The telephone rings when there is an incoming call. The MESSAGE WAITING LED and the respective line key flash.
To answer a call using the corded handset:
Lift the cordless handset and it connects to the ringing line. The respective line key illuminates when in use.
To answer a call using the telephone base:
Press the flashing line key, or press
/SPEAKER to pick up the ringing line. The respective line key and the /SPEAKER key
illuminate when in use.
Place a call
Lift the corded handset, or press LINE 1, LINE 2, or /SPEAKER on the telephone base. Listen for a dial tone and then dial the
desired number, or press a Speed Dial key to dial a programmed number. The respective line key illuminates when in use. The
/SPEAKER key illuminates when in speakerphone mode.
End a call
Place the corded handset in the telephone base, or press /SPEAKER or the active line key when in speakerphone mode.
Switch a call between the corded handset and the telephone base speakerphone
To switch a call from the corded handset to the telephone base speakerphone, press /SPEAKER on the telephone base,
then place the corded handset on the telephone base cradle. The active line is selected. When both lines are in use or on hold,
LINE 1 is selected.
To switch a call from the telephone base speakerphone to the corded handset currently on the telephone base cradle, lift the
corded handset from the telephone base cradle. The active line is selected. When both lines are in use or on hold, LINE 1
is selected.
To switch a call from the telephone base speakerphone to the corded handset which is not on the telephone base cradle, press
/SPEAKER on the telephone base. The active line is selected. When both lines are in use or on hold, LINE 1 is selected.
Share a call
During a call, parallel telephones (telephones on the same line) can join the call.
To join a call:
During a call on line 1 or line 2, press the respective line key to join.
Speakerphone
When the telephone is idle, press /SPEAKER. The first available line is selected, starting with line 1.
During a call on the handset, press /SPEAKER. The active line is selected. When both lines are in use or on hold, LINE 1
is selected.
Volume
Listening volume and ringer volume can be adjusted from the telephone base.
To adjust the listening volume:
During a call, press
+/- VOLUME to adjust the listening volume. The next call returns to the default listening volume.
To adjust the ringer volume:
At any time, slide the
RINGER VOL switch on the right side of the telephone base to adjust the ringer volume.
Call waiting
When you hear a call waiting tone during a call, press FLASH on the telephone base to put your current call on hold and take the
new incoming call.
Press
FLASH or the switch hook once rapidly at any time to switch back and forth between calls.
•
•
•
•
•
1.
2.