Veris Technologies EC Force Probe - Operating Instructions - Manual (Page 4)

OM17-P4000 Force/EC
2-1
Section 2
VERIS P4000 Probe Platform
System Overview
Before you begin using your P4000, it’s important to familiarize yourself with the basic
components and controls
Pre-operation checks:
1) Engine oil Level – refer to Honda GX 670 engine manual
2) Hydraulic fluid -- fluid level should be at or near upper black line on sight gauge
of hydraulic reservoir. (Figure 1). If not add suitable ISO 32 hydraulic fluid with a
viscosity index of 95- 140. Unit is filled at factory with Mobilfluid 424.
3) Check gas level – unleaded gasoline only
4) Check for any loose fasteners or hydraulic leaks.
Controls:
1) Engine controls are located on the engine itself. (figure 2) . Refer to Honda
engine manual for detailed information.
Hyd sight
gauge
Fuel Tank
Figure 1
Starter Switch
Choke Throttle
Figure 2