Veris Technologies EC Force Probe - Operating Instructions User Manual
Page 22
OM17-P4000 Force/EC
5-9
1. Extend platform out to full extension
2. Attached chain binders on each side of probe
3. Slip anchor plates over anchors and bind down each side (figure 18)
- Anchoring will limit your side travel somewhat, but you should still be able to take
multiple cores with the anchors installed.
- Do not use extension control while anchors are connected
- Remove the anchors in reverse sequence.
- If anchors have shifted during use and you are unable to slide the hex head of
the anchor back into the hex drive
– use the foot to gently nudge the anchor back
into re-alignment.
Note: Be careful when lowering the probe with the instrument cases in
place. Remove left hand anchor first
– otherwise you might push the head
of the anchor into the instrument mount when lowering probe to remove
RH anchor.
Figure 18