Veris Technologies EC Force Probe - Operating Instructions - Manual (Page 15)

OM17-P4000 Force/EC
5-2
5) Using the
“L” straps as templates, you can drill the hole through the bottom side of the skid
frame rail. Tip: If you start out with small pilot holes (
1/4”or less) it takes less
effort to drill through the bed and frame rail, then drill out to full dimension from
on top.
6) If for some reason you must locate one or two of lower “L” mounts ahead or
behind the skid frame rail, you can fabricate some clips to hold down in place.
Ideally at least two bolts should go through the skid frame to ensure that probe is
properly connected to bed (Figure 3)
7) Securely bolt down and connect power cable to battery of vehicle.
Figure 1
Figure 2A & B
Start out with ¼”
pilot hole for
drilling up through
bed, then enlarge
to ½” or larger
from on top
Top View
Figure 3
Figure 4