Shogun Motorsports Suzuki GSXR600_750 (2011) NO CUT Frame Slider - Manual (Page 5)

5.
6.
Remove right side engine stud.
7.
Mount right side offset to the motorcycle. Read your service manual for specific torque
specifications associated to those locations. Use (99-HB-SH10125060) 10 X 1.25 X 60 Socket cap
bolt to mount offset to the motorcycle. Torque down main engine stud. Tip: DO NOT use blue
thread locker on either bolts discussed in this section. Start bolt in by hand make sure you have
good thread engagement -
do not cross thread . No washer is needed for right side offset .
8.
Mount bodywork. On the left side you will need to guide the body panel up the offset as you
tighten body screw shown in this photo. This Shogun kit has a very tight fit on both the left and
right side this is to ensure the maximum strength of the offsets.