Shogun Motorsports BMW S1000RR (12-13) NO CUT Frame Slider - Manual (Page 2)

3.
Mount right side offset to the motorcycle. Read your service manual for specific torque
specifications associated to those locations. Use (99-HB-SH10150060) 10 X 1.50 X 60 Socket cap
bolt to mount offset to the motorcycle. Leave conical spacers in the frame and torque down
main engine stud. Tip:
DO NOT use blue thread locker on the bolt discussed in this section. Start
bolt in by hand make sure you have good thread engagement do not cross thread or over
tighten . Note: Offset shown in this illustration has a raw finish all offsets come black anodized
with a machined finished threaded spacer.
4.
5.
Remove left side main engine stud.
6.
Mount left side frame slider to the motorcycle. Read your service manual for specific torque
specifications associated to those locations. Use (99-HB-SH10150090) 10 X 1.50 X 90 Socket cap
bolt to mount left side frame sliders to the motorcycle. Leave conical spacers in the frame and
torque down main engine stud. Tip: DO NOT use blue thread locker on the bolt discussed in this
section. Start bolt in by hand make sure you have good thread engagement do not cross thread
or over tighten.