Ohaus VX SERIES FLOOR SCALES Indicator T32XW Manual en User Manual
Page 30
EN-2
3000 Series Indicators
. Application Modes
Only modes enabled n the mode menu wll be dsplayed (refer to Secton 3-6).
.. Weighing
Place the tem to be weghed on the scale. The llustraton ndcates a sample of 1.5 kg, Gross
weght.
Note: To return to the Weghng mode from the Parts Countng mode, press and hold the
Mode
button untl WEIGH s dsplayed.
. Changing Units of Measure
Press and hold the
Units button untl the desred measurng unt appears. Only measurng unts enabled n the Unt Menu
wll be dsplayed (refer to Secton 3.7).
. Printing Data
Prntng the dsplayed data to a prnter or sendng the data to a computer requres that the communcaton parameters n the Prnt
Menu are set (refer to Secton 3.8).
Press the
Units button to send the dsplayed data to the communcaton port (the Auto-Prnt Mode n Secton 3.8 functon
must be Off).
..2 Parts Counting
Use ths mode to count parts of unform weght. The Indcator determnes the quantty based on the
average weght of a sngle part. All parts must be unform n weght for accurate measurements.
To enter the Parts Countng mode, press and hold the
Mode button untl Count s dsplayed.
Average Piece Weight (APW)
When the
Mode button s released, CLr.PW Pcs s dsplayed.
NOTE: If no APW has been prevously stored, the CLr.PW dsplay s skpped and the dsplay shows
PUt10Pcs.
Clearing a Stored APW
Press the
Yes button to clear the stored APW.