Ohaus VX SERIES FLOOR SCALES Indicator T32XW Manual en - Manual (Page 29)

EN-2 3000 Series Indicators
3.. End Lock
Advance to the next menu.
3.. Lock Print
Set the status.
OFF = Prnt menu s not locked.
ON = Prnt menu s locked.
3.0 Security Switch
A securty swtch s located on the Man PCB board. When the swtch s set to the on poston, user menu settngs that were
locked n the Menu Lock can not be changed.
Open the housng as explaned n Secton 2.3.1. Set the poston of securty swtch to ON as shown n Fgure 1-3.
OPERATION
. Turning Indicator On/Off
To turn the Indcator on, press the and hold the ON/ZERO Off button for 2 seconds. The Indcator
performs a dsplay test, momentarly dsplays the software verson, and then enters the actve
weghng mode.
To turn the Indcator off, press and hold the ON/ZERO Off button untl OFF s dsplayed.
.2 Zero Operation
Zero can be set under the followng condtons:
• Automatcally at Power On (ntal zero).
• Sem-automatcally (manually) by pressng the
ON/ZERO Off button.
• Sem-automatcally by sendng the Zero command (Z or alternate zero command).
Press the ON/ZERO Off button to zero the weght dsplay. The scale must be stable to accept zero
operaton.
.3 Manual Tare
When weghng an tem that must be held n a contaner, tarng stores the contaner weght n
memory. Place the empty contaner on the scale (example 0.5 kg) and press the
TARE button.
The dsplay wll show the net weght.
To clear the Tare value, empty the scale and press the TARE button. The dsplay wll show the
gross weght.