Ohaus Scout II Electronic Balances - Manual (Page 8)

8
MENU DESCRIPTION
The User Menu permits you to activate the Auto Shut-off feature, select weighing
units, select parts counting, select printing parameters on RS232 equipped mod-
els and perform Linearity calibration and store settings. Bolded items shown in the
menu are factory default settings. Each menu item is covered in a separate proce-
dure in this manual, to enter an individual menu item and select it requires alter-
nating between the Mode Off and Zero On buttons.
To enter the menu, start with the balance OFF, press and hold Zero On until
MENU is displayed, then release it. The first menu item A. OFF (automatic
shutoff) is displayed. Refer to the individual procedures to select and enable
menu items.
MENU
A.OFF - Set to On or Off.
UNITS - g, oz, lb, oz t, dwt, pc, set each to On or Off.
PRINT*-Power - On or Off.
Baud Rate - 300, 1200, 2400, 4800, 9600
Data Bits - 7 or 8
Parity Bit - Odd, Even or None
Stop Bits - 1 or 2
Auto Print - Continuous, On Stability, or Off
Stable Data Output Only - On or Off
End.
LIN - Performs linearity calibration.
END - Exit menu and store settings.
* RS232 models only.
AUTO SHUT-OFF ACTIVATION
When Auto Shut-off is activated, the balance will shut off after three minutes of non
use. To activate auto shut-off, proceed as follows:
1. Start with the balance OFF. Press Zero On until MENU is displayed. When
Zero On is released, A. OFF is displayed.
2. With A. OFF displayed, press Zero On to view current state (ON or OFF).
3. Press Mode Off to change the displayed setting to either On or OFF .
4. To accept the displayed setting, press Zero On. The display returns to
A. OFF .
5. Press Mode Off until End is displayed, then press Zero On to store and
save setting. Balance is now in a weighing mode.