Ohaus Scout II Electronic Balances - Manual (Page 6)

6
BOTTOM OF
BALANCE
WEIGH BELOW HOOK
SECURITY
BRACKET
Weigh Below Hook
For below balance weighing applications (eg. density determination), the weigh
below hook may be installed at the bottom of the balance as shown.
Do not over tighten the screw, tighten finger tight. Place the balance on a suit-
able stand which will allow below balance weighing.
Security Bracket
A security bracket is provided at the rear of the balance which allows the balance
to be secured by the optional cable and lock accessory.
IMPORTANT INFORMATION
Scout II balances are sensitive, precision devices and when shipped, occasion-
ally require calibration before they are used. The balances are calibrated at the
factory and due to rough handling and vibration during shipping, the balance may
display an ERR1 or ERR4 when first turned on.
This does not mean that the balance is defective. We recommend you perform
span calibration for an ERR1 indication and linear calibration for ERR4 before
you call for service. If the balance does not span calibrate, try linear calibration.
Linear calibration requires two masses to be used. The 200g, 400g and 600g
balances are shipped with one mass, you will require a second mass which can
be ordered from Ohaus. 1200g and 6000g balances are not shipped with masses.
Refer to the accessory table at the rear of the manual for the required calibration
masses.
Review the Menu and then perform both Span and Linear calibration. Span
calibration does not require entering the Menu. Linear calibration (LIN) does re-
quire entering the Menu.
In the event the balance fails to operate properly, please call Ohaus Corporation
toll-free at (800) 526-0659 for service or parts.
INSTALLATION (Cont.)
be ordered from Ohaus. 1200g, 4000g and 6000g units are not shipped with masses.