Ohaus Scout II Electronic Balances - Manual (Page 12)

12
SETTING PRINT MENU FUNCTIONS
This procedure permits you to set one or all of the RS232 communication param-
eters on balances equipped with RS232. Each parameter can be entered and set
individually.
ENTERING THE PRINT MENU
1. Start with the balance OFF. Press Zero On until MENU is displayed.
2. Press Mode OFF until Print is displayed.
3. With Print displayed, press Zero On until PoWr is displayed. You may now
select to change any of the parameters in Power, Baud Rate, Data Bits,
Parity Bit, Stop Bits, Auto Print, Stable Data or End which saves all settings.
4. By repeately pressing Mode Off, you can enter any one of the above print
menu items. See following procedures.
POWER ON/OFF
1. With PoWr displayed, press Zero On.
2. Press Mode Off to change the displayed setting to On or OFF .
3. To accept the displayed setting, press Zero On. The display returns to
PoWr . To advance to Baud Rate, press Mode Off. If you don’t want to
change any other settings, press Mode Off until End is displayed, then
press Zero On to save settings.
BAUD RATE
1. With bAud displayed, press Zero On until either 300, 1200, 2400, 4800 or
9600 is displayed.
2. Press Mode Off to change the displayed setting to either 300, 1200, 2400,
4800 or 9600 baud.
3. To accept the displayed setting, press Zero On. The display returns to
bAud . To advance to Data Bits, press Mode Off. If you don’t want to change
any other settings, press Mode Off until End is displayed, then press Zero
On to save settings.