Ohaus Scout II Electronic Balances - Manual (Page 7)

7
STABILITY
INDICATOR
LOW BATTERY
INDICATOR
WEIGHING UNIT
INDICATORS
Balance Display
*
TURNING THE BALANCE ON
Press Zero On. All segments will appear briefly followed by a software revision
number and then 00 g . Allow 5 minutes warm-up time.
TURNING THE BALANCE OFF
To turn the balance OFF, press and hold Mode Off until the display indicates OFF ,
then release.
WEIGHING
The balance is shipped from the factory ready to weigh in g, oz, oz t, dwt and lb.
1. Select the desired weighing unit by momentarily pressing Mode Off.
2. If it is necessary to rezero the display, momentarily press Zero On.
3. Place item(s) to be weighed on the pan and read the weight on the display.
The stability indicator appears when the reading is stable.
TARING
When weighing items that must be held in a container, taring subtracts the container's
weight from the total weight on the pan. Remember, the weight of the container
and the material it holds must not exceed the capacity of the balance.
1. With an empty container on the pan, press Zero On to zero the display.
2. As material is added to the container, the net weight is displayed. Tared
weight remains in balance memory until Zero On is pressed again.
3. If the container is no longer used and is removed from the balance, the
display indicates a negative weight which was the container’s weight.
Press Zero On to zero the display.
BAT
PC
oz t
dwt
g
lb