AASTRA Office 10 User manual - Manual (Page 16)

Using Added Features to Make Efficient Phone Calls
16
Suppressing your call number from your called party's terminal
display
You do not want your call number to appear on the terminal display of a called party in the public
network.
You have two possibilities [b] :
• If you never want your call number to appear, you can ask your system administrator to set up the
system configuration accordingly.
• To suppress your call number display for certain calls only, select the function "CLIR per call" before
dialling your party's call number. You can store the function under a function key or activate it with a
*/# procedure.
The CLIR per call function is available on a function key.
Activating / Deactivating Functions by Remote Control
You are not at your desk and want to set various functions on your phone from a different phone.
You can activate / deactivate many of your phone's functions by remote control from a different phone.
Remote control has to be enabled for your phone in the system.
Remote control is possible from within and from outside the system [d] . For external remote control,
the system administrator has to give you the dial-in number.
The remote control is initiated using a special */# procedure. You can then enter the function commands
and */# procedures in the usual way.
Before the call: Press the CLIR per call function key.
Note Suppressing your phone number from the display only works with external
calls and has to be subscribed to with your provider.
To remote control from a third-party phone: Pick up the handset.
To initiate remote control:
Enter */# procedure *06.
Enter your phone number.
Enter the */# procedure for activating / deactivating the function you want.
Put the handset on-hook.
☛
☛