AASTRA 6739i for OpenCom 1000 User Guide EN - Manual (Page 16)

Using the Aastra 6739i
12
Using a Headset
Instead of using a handset, a headset can be connected to the Aastra 6739i. You
can press the
handsfree key in this case in order to accept and end calls.
You can configure whether to use the headset or the speaker for handsfree oper-
ation via the menu Options list > Audio (see Settings via the Options Menu
starting on page 27).
Note
Establishing a call can be delayed with SIP telephony. When using a headset, e.g.
you should wait a second before you begin to speak.
Speed Dialling
You can configure function keys with speed dialling destinations on the
Aastra 6739i (see Web Configurator of the OpenCom 1000 starting on page 20).
■ Pick up the handset and press the function key where the speed dialling
destination is programmed.
alternatively – when you wish to call in the handsfree mode:
■ Press the function key – with the handset down – where the speed dialling
destination is programmed.
Caller Lists
You can configure a function key with a caller list function (see Web Configurator
of the OpenCom 1000 starting on page 20). Use this function key to access the
caller lists managed on the OpenCom 1000 communications system. The function
key blinks red when the caller list contains no entries.
1. Press the function key with the caller list function.
The calls no reply list appears.
2. Use the navigation keys to go to the desired entry.
3. To call the caller back, pick up the handset or press the softkey.
The call number is called. The display shows a picture (photo) of the called
subscriber if an image has been saved on the OpenCom 1000 communications
system (please refer to page 31).