beautypg.com

Garmin GPSMAP 182C User Manual

Page 102

background image

96

GPSMAP 182/182C Owner’s Manual

A

PPENDIX

>

M

OUNTING

THE

GPSMAP 182/182C U

NIT

To flush mount the GPSMAP 182/182C unit using the

gimbal mounting bracket:

1. Cut a 4.33

"

x 4.33

"

(110 x 110 mm) hole in the panel.

2. Place the GPSMAP 182/182C into the hole from the front

until the flange rests against the mounting surface.

3. From the back of the panel, loosely attach the bracket so

the slot in the ratchet area points away from the mounting

panel (figure 1).

4. Rotate the bracket downward until the panel is pinched

tightly between the unit’s flange and bracket lobe (figure 1).

5. Tighten the knobs and connect the power/data and antenna

cables.

NOTE: if the panel is too thick to allow use of the supplied

knobs, use two M6 screws to secure the bracket.

Figure 1

Pull gimbal bracket

down until cam lobe

contacts surface.

The GPSMAP 182/182C, with external antenna, can be flush

mounted on a flat panel using its existing mounting bracket.

To flush mount the GPSMAP 182/182C:

1. Remove the four M5 screws from the back of the unit and

remove the mounting bracket.

2. Using the mounting bracket as a template, outline the

center relief area and mark the location of the four screw

holes centers on your bulkhead or other surface (figure 2).

3. Cut the relief hole from the panel and drill the four 0.20"

(5.08 mm) screw holes.

4. Place the GPSMAP 182/182C into the relief hole until it

rests flush against the mounting surface.

5. Secure the unit to the mounting surface using the M5

screws. Do not try to force the screws deeper into the holes

than the holes allow. For thick mounting surfaces, insert

the M5 screws directly thru the drilled holes (figure 3). For

thin panels, place the mounting bracket on the back side

of the panel for more support. Connect the power/data and

antenna cables.

Figure 2

Figure 3