beautypg.com

Turning on the gpsmap 2206/2210, Adjusting the backlight – Garmin GPSMAP 2210 User Manual

Page 12

background image

GPSMAP 2206/2210 Owner’s Manual

g

ettIng

s

tArted

>

t

urnIng

on

the

gPsMAP 2206/2210

Turning on the GPSMAP 2206/2210

Before you turn on the GPSMAP 2206/2210, make sure the unit and GPS 17

antenna are correctly installed on your vessel according to the instructions in the

GPSMAP 2206/2210 & GPS 17 Installation Instructions.
The first time you turn on the GPSMAP 2206/2210, the GPS 17 receiver

must collect satellite data and determine its current location. To ensure proper

initialization, the GPSMAP 2206/2210 is shipped from the factory in AutoLocate

mode.

To turn on the GPSMAP 2206/2210:

1. Press and hold the

POWER key until the unit turns on.

2. When

I Agree is highlighted on the Warning Page, press ENTER to open

the Map Page.

NOTE: The first time you turn on the unit, you are asked if you want to start

the retail demonstration. Select No, and press ENTER.

To turn off the GPSMAP 2206/2210:

Press and hold the

POWER key until the unit turns off.

Adjusting the Backlight

You can adjust the screen backlighting on the GPSMAP 2206/2210 from any

page by using the POWER/BACKlIGhT key.

To adjust the backlight level:

1. Press and release the

POWER/BACKLIGHT key.

2. Press up on the

ROCKER to increase the brightness, or press down to

decrease.

TIP: After you open the Backlight adjustment window, press the

POWER/BACKlIGhT key repeatedly to cycle through the three

backlight settings: Highest, Middle, and Lowest.

Highest

Middle

Lowest

3. Press

ENTER or QUIT to close the Backlight adjustment window.