beautypg.com

Garmin GPSMAP 238 Sounder User Manual

Page 116

background image

106

Appendix F

Messages

Battery Voltage High Please Check Connection— Input DC voltage is
too high for unit.
Battery Voltage Low Please Check Connection— Input DC voltage is
too low for unit.
Boat is Not Moving Fast Enough to Calibrate— Speed wheel is not
turning. Check for debris or boat speed is too slow.
Database Error— Internal problem with the unit. Contact your dealer or
Garmin Customer Service (pg. iv) to have the unit serviced.
Deep Water Alarm— Specifi ed deep water alarm depth has been detected
below transducer.
Lost Satellite Reception— The unit has lost satellite signals. Check
antenna connections or try moving to a location with a clear view of the sky.
Memory (RAM) Failed Unit Needs Repair— Internal problem with the
unit. Contact your dealer or Garmin Customer Service (pg. iv) to have the
unit serviced.
Memory (ROM) Failed Unit Needs Repair— Internal problem with the
unit. Contact your dealer or Garmin Customer Service (pg. iv) to have the
unit serviced.
No DGPS Position— No differential correction data is available or not
enough data is available to compute a DGPS position.
No Tide Stations For That Area— There are no tide stations within 100
miles of the specifi ed point. Try another area.
Off Course Alarm— You have exceeded the specifi ed off-course distance.
Processor Failed Unit Needs Repair— Internal problem with the unit.
Contact your dealer or Garmin Customer Service (pg. iv) to have the unit
serviced.

The GPSMAP 188/188C/238 Sounder uses an on-screen pop-up mes-

sage system to alert you to unit operating characteristics. Press the ENTER
key to acknowledge and return to the page you were viewing.

Alarm Clock— The alarm clock has sounded.
Alarm Voltage Set Too High— Voltage range must be between 8.0 and
35.0 volts for the GPSMAP 188/238 (GPSMAP 188C 10.0 to 35.0 volts).
Alarm Voltage Set Too Low — Voltage range must be between 8.0 and
35.0 volts for the GPSMAP 188/238 (GPSMAP 188C 10.0 to 35.0 volts).
Anchor Drag Alarm— You have drifted out of the specifi ed distance
range.
Antenna Input Shorted To Ground— Check antenna wiring/connections
or antenna replacement.
Approaching Waypoint— You are a specifi ed alarm distance from a
destination waypoint.
Arrival At Waypoint— You have arrived at the destination waypoint.
Basemap Failed Unit Needs Repair— Internal problem with the unit.
Contact your dealer or Garmin Customer Service (pg. iv) to have the unit
serviced.
Battery Alarm— Specifi ed amount of input voltage has been detected.

188188C238 Manual Part 2.indd 106

6/30/2003, 3:32:48 PM