ACU-RITE 300S - Manual (Page 39)

300S 25
I - 3 Milling Specific Oper
ations
Entering tool data
8 Choose TOOL soft key.
8 Cursor to the desired tool and press ENTER. The Tool Description
form will appear.
8 Enter the tool diameter.
8 Enter the tool length or press TEACH LENGTH.
8 Enter the tool units (inch/mm).
8 Enter the tool type.
8 Spindle data is not required unless the Spindle Speed Control has
been installed. If installed, then refer to the CSS I/O User’s Manual.
8 Press C to return to the tool table. Press C to exit.
Tool Table Usage
Example: Entering the tool length and diameter into the tool table.
Tool diameter 2.00
Tool length: 20.000
Tool unit: mm
Tool type: flat end mill
It is also possible to have 300S determine the length of an
offset. See - ALTERNATIVE METHOD -.
Spindle Speed Control information is only required when
CSS I/O option box is installed. Refer to the CSS I/O User
Manual if this has been installed.