Pc 6415 – Acnodes PC 6415 User Manual

Page 50

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909.597.1939

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

PC 6415

15” Fanless Panel PC

Step 5: Lift the cover off and pull down the cover a bit to make it possible to lift the

cover further more after removing the retention screws. More strength is required to

separate the cover from the chassis.

5.5 Replacing Components

5.5.1 Memory Module Replacement

The flat panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory

module fails, follow the instructions below to replace it.

Step 1: Remove the aluminum back cover. See Section 5.4.1 above.

Step 2: Locate the DDR2 SO-DIMM on the motherboard (Figure 5-2).

Step 3: Remove the DDR memory module by pulling both the spring retainer clips

outward from the socket.

Step 4: Grasp the DDR memory module by the edges and carefully pull it out of the

socket.

Step 5: Install the new DDR memory module by pushing it into the socket at an angle.

Step 6: Gently pull the spring retainer clips of the SO-DIMM socket out and push the

rear of the DDR memory module down (Figure 5-3).

Step 7: Release the spring retainer clips on the SO-DIMM socket. They clip into place

and secure the DDR memory module in the socket.