Pc 6415 – Acnodes PC 6415 User Manual
Page 31
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at
PC 6415
15” Fanless Panel PC
4.8.1 AT POWER MODE
When AT mode is selected, power is controlled by a central power unit rather than a
power switch. The PC Series-N270 panel PC turns on automatically when the power is
connected. The AT mode benefits a production line to control multiple panel PCs from
a central management center and other applications including:
"
ATM
"
Self-service kiosk
"
Plant environment monitoring system
"
Factory automation platform
"
Manufacturing shop flow
4.8.2 ATX POWER MODE
When ATX mode is selected, the PC Series-N270 panel PC goes into a standby mode
when turned off. The panel PC can be easily turned on via network or a power switch in
standby mode. Remote power control is perfect for advertising applications since the
broadcasting time for each panel PC can be set individually and controlled remotely.
Other possible applications include:
"
Security surveillance
"
Point-of-Sale (POS)
"
Advertising terminal
4.9 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an electrical circuit. It consists of two or
three metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To CLOSE/SHORT a jumper means connecting
the pins of the jumper with the plastic clip and to OPEN a jumper means removing the
plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the PC Se-
ries-N270. Before the PC Series-N270 is installed, the jumpers must be set in accor-
dance with the desired configuration. The jumpers on the PC Series-N270
motherboard are listed in Table 4-1.