Rmc 5015, Xpci/pnp configuration – Acnodes RMC 5015 User Manual

Page 65

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

RMC 5015

1U Rackmount System

32-Bit Data Transfer

Select Enabled to enable 32-Bit data transfer. The options are Enabled and Disabled.

Hard Disk Write Protect

Select Enabled to use the feature of Hard Disk Write Protect to prevent data from being written to
HDD. The options are Enabled or Disabled.

IDE Detect Time Out

Use this feature to set the time-out value for the BIOS to detect the ATA, ATAPI

devices installed in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30, and 35.

XPCI/PnP Configuration

This feature allows the user to set the PCI/PnP configurations for the following items:

Clear NVRAM

Select Yes to clear NVRAM during system boot. The options are Yes and No.

Plug & Play OS

Select Yes to allow the OS to configure Plug & Play devices. (This is not required for system boot if
your system has an OS that supports Plug & Play.) Select No to allow the AMI BIOS to configure all
devices in the system.

PCI Latency Timer

This feature sets the latency Timer of each PCI device installed on a PCI bus. Select

64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64, 96, 128, 160, 192, 224 and
248.

Allocate IRQ to PCI VGA

Select Yes to allow the system to give the VGA adapter card an interrupt address. The options are
Yes and No.

Palette Snooping

Select Enabled to inform the onboard PCI devices that an ISA graphics device is installed in the
system in order for the graphics card to function properly. The op- tions are Enabled and Disabled.