Acnodes RMC 5015 - Manual (Page 33)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 5015
1U Rackmount System
5-5 Onboard Processor
The Intel Atom processor is soldered directly onto the motherboard. Installing and removing the proces-
sor is not required. A small active heatsink (with fan) sits on the processor to keep it cool.
5-6 Installing Memory
Note: Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules to prevent any possible damage.
DIMM Installation
1. Insert the desired number of DIMMs into the memory slots, starting with DIMM1A. Insert each DIMM
vertically into its slot. Pay attention to the notch along the bottom of the module to prevent incorrect
installation.
2. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat step 1 to install DIMM1B if needed. See diagrams on the following page.
Memory Support
The embedded board supports up to 2GB Unbuffered Non-ECC DDR2 533/400 in two DIMM slots.
Populating these DIMM modules with a pair of memory mod- ules of the same type and same size will
result in interleaved memory, which will improve memory performance.